Winding the watch

  1. Unscrew the crown by turning it anti-clockwise until it pops out
  2. Don't pull it out any further. It winds at the "zero clicks"position
  3. Wind around 10-15 times in a clockwise direction until the watch starts moving
  4. Push the crown back in
  5. Tighten it by pushing in and turning clockwise until it's tightly screwed down

Note: If the watch is already moving, you probably don't need to wind it further. Just wearing it will keep it wound up. If you wear the watch every day you do not need to wind it in the morning when you put it on.

Setting the time

  1. Unscrew the crown by turning it anti-clockwise until it pops out
  2. Pull the crown out as far as it will go (you should feel a couple of small clicks. Don't pull too hard!)
  3. Set the time by turning the crown anti-clockwise, ensuring that you only go forwards in time, never backwards.
  4. Push the crown back in
  5. Tighten it by pushing in and turning clockwise until it's tight

Setting the day & date

  1. Unscrew the crown by turning it anti-clockwise until it pops out
  2. Pull the crown out gently until you feel one click
  3. Set the date by turning the crown clockwise
  4. Set the day by turning the crown anti-clockwise
  5. Push the crown back in
  6. Tighten it by pushing in and turning clockwise until it's tight

Adjusting the bracelet

The Nanok bracelet uses a combination of screws and pins. Internal links use hidden pins, adjustable links use single ended screws.

Use a 1mm screwdriver to remove links that you do not need. You can only remove links that will not damage the bracelet, so do not worry about removing screws to adjust it.

It is recommended to try to remove links evenly (or close to evenly) from each side of the bracelet so that the strap stays even. Some people find it slightly more comfortable to remove around 2 thirds from the end of the bracelet that attaches to the bottom of the watch and 1 third from the end that attaches to the top. Do what works for you.

Swimming in the Nanok

The Nanok is water resistant to 100 meters/10ATM. That means it's safe to swim in and for general water sports, but should not be used for professional diving.

Always make sure that the crown is fully screwed down before taking the Nanok in the water, as if the crown is loose it will be easy for water to get in!

Did this answer your question?